CVE-2019-20004
Official description Straight from the sourceThe vendor's or NVD's own wording, published unedited. Authoritative, but often terse — it says what broke, rarely what to do.
NVD · uneditedAn issue was discovered on Intelbras IWR 3000N 1.8.7 devices. When the administrator password is changed from a certain client IP address, administrative authorization remains available to any client at that IP address, leading to complete control of the router.
Technical summary Written by usOur analysis, written from the advisory, the CVSS vector and the affected-version data. It adds context the advisory leaves out, and never invents facts that are not in the source.
dbcve analysis · high confidenceThe Intelbras IWR 3000N 1.8.7 router implements IP-based session management where administrative authentication becomes permanently bound to the source IP address after a password change. Once the admin password is modified from a specific client IP, any device using that IP address can access the administrative interface without credentials, achieving full router control.
Verify against the referenced sources before acting — the references below are authoritative for this CVE, this summary is not.
Affected products & versions What the vendor confirmedThe version ranges the vendor confirmed as vulnerable. If your version sits inside a range here, treat yourself as exposed until you have upgraded.
NVD · CPE data= 1.8.7CVSS breakdown How the score is builtThe industry scoring standard. It rates how the flaw is reached, what it takes to exploit, and what an attacker gains — the score is derived from those, not the other way round.
From the vector- Attack vector
- Network
- Complexity
- Low
- Privileges
- None
- User interaction
- Required
- Scope
- Unchanged
- Confidentiality
- High
- Integrity
- High
- Availability
- High
CVSS:3.1/AV:N/AC:L/PR:N/UI:R/S:U/C:H/I:H/A:H
Am I affected? How to checkSteps we derive from the advisory and the affected-version data, so you can decide whether this CVE reaches your setup. They are a guide, not a scan — your own configuration is the authority.
dbcve checksWork through these to decide whether this CVE applies to you.
-
Identify firmware versionAccess the router's web administration interface (typically at 192.168.1.1 or similar) and navigate to System Status, Firmware Information, or About section to retrieve the installed firmware versionAffected if Firmware version is exactly 1.8.7
-
Confirm password change historyReview router admin logs or configuration to determine if the administrator password has ever been changed since initial deploymentAffected if Password has been changed from a specific client IP address
-
Test IP-bound session behaviorAccess the admin interface from the same IP address previously used to change the password, then attempt to access without re-entering credentialsAffected if Administrative interface is accessible without authentication from an IP that was used for a prior password change
-
Verify session persistence across IPsAttempt to access the admin interface from a different IP address than the one used for password change, then compare authentication requirementsAffected if Different IP addresses have different authentication requirements for the same admin session
The router is affected if running firmware 1.8.7 and the admin password was changed from a specific client IP, allowing unauthenticated access from that IP.
Generated from the published advisory. Verify against your own configuration.
Remediation Closing itWhat it takes to close this. Where a vendor fix exists we point at it; where none exists we say so plainly, and can build one. Effort estimates are scoped from the advisory, not from your codebase.
From vendor dataApply vendor firmware patches if available; otherwise isolate the device on a restricted network segment and ensure password changes are performed from dedicated IPs not accessible to other clients.
- Consultation2.0 h
- Implementation4.0 h
- Testing3.0 h
- Review / QA2.0 h
An estimate, not a bill — we confirm scope with you before any work starts. Need it this week? Rush from $3,088.
Scan for this in your stack
Free · runs locallyCheck whether your project pulls in CVE-2019-20004 — or any other known-vulnerable package — straight from your lock files. Free and open source; it runs locally and uploads nothing.
References Go to the primary sourcePrimary sources — vendor advisories, patches and trackers. Where our summary and a reference disagree, the reference wins.
Primary sourcesPractitioner notes
ContributedPeer-ranked notes from engineers who’ve handled CVE-2019-20004 in production — separate from our analysis above.
The advisory tells you what broke. It rarely tells you what actually worked. If you’ve dealt with this one, that detail is what the next engineer is searching for.
- The version that genuinely resolved it — not the one the vendor claimed
- A config change or rule that shut the vector down
- A gotcha in the upgrade path that cost you an afternoon
No notes yet
Be the first to add a field note for this CVE — a mitigation you’ve verified, a version caveat, or a link to a working fix. Sign in above to contribute.
A place for practitioners to share what actually worked: a mitigation you’ve tested, a configuration change, a version- or environment-specific caveat, or a link to a verified patch. The most useful notes rise to the top as peers upvote them, so the signal stays high.
- Verified mitigations, workarounds, and config changes
- Version or environment caveats, and links to real fixes
- No weaponised exploit code, or anything meant to cause harm
- No spam, self-promotion, credentials, or personal data