Rv110w FirmwareOperating system · Cisco

CVE-2021-1165

HIGH · 7.2 CVSS v3.1 Published 2021-01-13
Mitigation only
No fix yet — a mitigation exists. There is no fixed release. A documented workaround reduces exposure in the meantime.
See remediation →
78/100
Remediation priority · High
Remotely reachable Zero-click

Official description Straight from the sourceThe vendor's or NVD's own wording, published unedited. Authoritative, but often terse — it says what broke, rarely what to do.

NVD · unedited
Multiple vulnerabilities in the web-based management interface of Cisco Small Business RV110W, RV130, RV130W, and RV215W Routers could allow an authenticated, remote attacker to execute arbitrary code or cause an affected device to restart unexpectedly. The vulnerabilities are due to improper validation of user-supplied input in the web-based management interface. An attacker could exploit these vulnerabilities by sending crafted HTTP requests to an affected device. A successful exploit could allow the attacker to execute arbitrary code as the root user on the underlying operating system or cause the device to reload, resulting in a denial of service (DoS) condition. To exploit these vulnerabilities, an attacker would need to have valid administrator credentials on the affected device. Cisco has not released software updates that address these vulnerabilities.

Technical summary Written by usOur analysis, written from the advisory, the CVSS vector and the affected-version data. It adds context the advisory leaves out, and never invents facts that are not in the source.

dbcve analysis · high confidence

Multiple input validation vulnerabilities in the web-based management interface of Cisco Small Business RV series routers (RV110W, RV130, RV130W, RV215W) allow authenticated remote attackers to inject arbitrary commands via crafted HTTP requests. Successful exploitation yields root-level code execution on the underlying Linux OS or causes device reload (DoS). The vulnerabilities stem from lack of proper sanitization of user-supplied parameters in HTTP requests to the management interface.

MitigationSince Cisco has not released patches, implement network-based controls: restrict web management interface access to trusted IPs only, use VPN for administrative access, or replace with supported hardware. If the devices cannot be replaced, isolate them behind a firewall with strict ACLs limiting management access to authorized management stations.

Verify against the referenced sources before acting — the references below are authoritative for this CVE, this summary is not.

Affected products & versions What the vendor confirmedThe version ranges the vendor confirmed as vulnerable. If your version sits inside a range here, treat yourself as exposed until you have upgraded.

NVD · CPE data
Rv110w FirmwareOperating system
Affected:= 1.2.2.8= 1.3.1.7
Rv130 Vpn Router FirmwareOperating system
Affected:= 1.2.2.8= 1.3.1.7
Rv130w FirmwareOperating system
Affected:= 1.2.2.8= 1.3.1.7
Rv215w Wireless N Vpn Router FirmwareOperating system
Affected:= 1.2.2.8= 1.3.1.7
Application Extension PlatformPlugin / extension
Affected:= 1.0.3.55

CVSS breakdown How the score is builtThe industry scoring standard. It rates how the flaw is reached, what it takes to exploit, and what an attacker gains — the score is derived from those, not the other way round.

From the vector
Attack vector
Network
Complexity
Low
Privileges
High
User interaction
None
Scope
Unchanged
Confidentiality
High
Integrity
High
Availability
High

CVSS:3.1/AV:N/AC:L/PR:H/UI:N/S:U/C:H/I:H/A:H

Am I affected? How to checkSteps we derive from the advisory and the affected-version data, so you can decide whether this CVE reaches your setup. They are a guide, not a scan — your own configuration is the authority.

dbcve checks

Work through these to decide whether this CVE applies to you.

  1. Identify the router model
    Log into the web management interface and locate the device information page, or check the physical device label for the model number (RV110W, RV130, RV130W, or RV215W)
    Affected if The device is any of these four models: RV110W, RV130, RV130W, or RV215W
  2. Check the firmware version
    In the web interface, navigate to Status > System Summary or similar, and note the firmware version displayed
    Affected if The firmware version is exactly 1.2.2.8 or 1.3.1.7
  3. Verify if web management interface is enabled
    In the web interface, go to Administration > Management Interface or similar, and confirm the HTTP/HTTPS management access is enabled
    Affected if Web-based management is enabled and accessible
  4. Check network exposure of management interface
    Review firewall rules or ACLs to determine if the management interface is reachable from untrusted networks (WAN interface or non-VLANed networks)
    Affected if The management interface is accessible from untrusted/external networks without VPN or ACL restrictions

You are affected if you have a RV110W, RV130, RV130W, or RV215W router running firmware version 1.2.2.8 or 1.3.1.7 with the web management interface enabled and exposed to untrusted networks.

Generated from the published advisory. Verify against your own configuration.

Check your environment

Paste your version and any relevant configuration and it will be compared against the affected criteria above. Do not include secrets or credentials.

AI-assisted, checked against the advisory. Informational, not a guarantee.

Remediation Closing itWhat it takes to close this. Where a vendor fix exists we point at it; where none exists we say so plainly, and can build one. Effort estimates are scoped from the advisory, not from your codebase.

From vendor data
Mitigation available No clean upgrade yet — mitigate in the meantime
Mitigation

Since Cisco has not released patches, implement network-based controls: restrict web management interface access to trusted IPs only, use VPN for administrative access, or replace with supported hardware. If the devices cannot be replaced, isolate them behind a firewall with strict ACLs limiting management access to authorized management stations.

Fix this in Rv110w Firmware Scoped from the published advisory
  • Consultation6.0 h
  • Implementation12.0 h
  • Testing8.0 h
  • Review / QA4.0 h
30.0 hours of engineering $5,280
Get help mitigating

An estimate, not a bill — we confirm scope with you before any work starts. Need it this week? Rush from $8,448.

Scan for this in your stack

Free · runs locally
dbcve dependency scanner

Check whether your project pulls in CVE-2021-1165 — or any other known-vulnerable package — straight from your lock files. Free and open source; it runs locally and uploads nothing.

References Go to the primary sourcePrimary sources — vendor advisories, patches and trackers. Where our summary and a reference disagree, the reference wins.

Primary sources

Practitioner notes

Contributed

Peer-ranked notes from engineers who’ve handled CVE-2021-1165 in production — separate from our analysis above.

No notes yet

Be the first to add a field note for this CVE — a mitigation you’ve verified, a version caveat, or a link to a working fix. Sign in above to contribute.

What this is

A place for practitioners to share what actually worked: a mitigation you’ve tested, a configuration change, a version- or environment-specific caveat, or a link to a verified patch. The most useful notes rise to the top as peers upvote them, so the signal stays high.

What belongs here
  • Verified mitigations, workarounds, and config changes
  • Version or environment caveats, and links to real fixes
  • No weaponised exploit code, or anything meant to cause harm
  • No spam, self-promotion, credentials, or personal data